11-19
11
IM 701830-01E
Saving/Loading the Data/Connecting to the PC
11.13 Connecting to a PC
You can connect a PC to the instrument via the SCSI. Once the connection is established, you
can use the PC to access the internal hard disk.
Items Required to Connect
• SCSI cable (half-pitch 50-pin, pin type)
Use a commercially sold SCSI cable that is 3 m or less in length with a ferrite core on each end
and a characteristic impedance of 90 to 132
Ω
.
Connection procedures
Changing the SCSI ID of the instrument
Before connecting the instrument to a PC, you may need to change the instrument’s SCSI ID so
that it does not conflict with the PC’s ID.
1.
Press the
MISC
key.
2.
Press the “
SCSI ID
” soft key.
3.
Press the “
Own ID
” soft key so that the jog shuttle action is set to Own ID.
Then turn the jog shuttle to select the new ID for the instrument.
4.
Press the “
Initialize SCSI
” soft key to register the new ID.
→
Changing the SCSI ID of the internal hard disk
Set the ID number of the internal hard disk drive so that it does not overlap with the ID’s of
other SCSI devices. For information on setting the ID, refer to Section 11.12 “Changing the
SCSI IDs.”
