2-8
IM 701730-51E
Setting the Trigger Level, Trigger Coupling, Etc.
22.
Press the Level/Coupling soft key. The Level/Coupling dialog box opens.
23.
Set the trigger level, trigger hysteresis, trigger coupling, and HF rejection of
each channel. For the setup procedure, see steps 9 to 13 on page 6-15 in the
DL1700E Series User’s Manual (IM701730-01E)
.
24.
Press ESC. The Level/Coupling dialog box closes.
Setting the Trigger Mode
25.
Set the trigger mode according to the procedures given in section 6.1, “Setting
the Trigger Mode” in the
DL1700E Series User’s Manual (IM701730-01E)
.
Setting the Record Length
26.
Set the record length according to the procedures given in section 7.2, “Setting
the Record Length” in the
DL1700E Series User’s Manual (IM701730-01E)
.
Starting/Stopping the SPI Bus Signal Acquisition
27.
Press START/STOP to start the SPI Bus signal acquisition. Triggers are
activated on the specified trigger conditions.
To proceed to the analysis, press START/STOP to stop the SPI Bus signal
acquisition.
2.4 Setting SPI Bus Signal Acquisition Conditions
