2
Note
Zero adjustment for resistance
We recommend that you perform zero adjustment to obtain accurate measurements.
After you perform steps and 2 above, short the test leads, and press the REL key.
(When zero adjustment is performed, the instrument will show a reading of 0.0 Ω.)
The zero adjustment value is used until the power is turned off.
4.3.5 Continuity Check ( )
CAUTION
To avoid damaging the instrument:
Before measurement, turn off the circuit under measurement so that no voltage is
applied.
) Turn the function switch to the “
” position.
2) Insert the test leads into the input terminals.
) Connect the test leads to the circuit under measurement
whose continuity you want to check.
If the circuit is continuous (less than approximately 50Ω),
the buzzer sounds.
Black Red
Test leads
4.3.6 Diode Test ( )
CAUTION
To avoid damaging the instrument:
Before measurement, turn off the circuit under measurement so that no voltage is
applied.
1) Turn the function switch to the “Ω” position.
Press SELECT to switch to diode measurement.
( is displayed.)
2) Insert the test leads into the input terminals.
) Connect the test leads to the diode, and then read the value
when it stabilizes.
Black Red
Test leads
