16-8
IM AQ1200-01EN
16.2 Loading a Project
CAUTION
Do not remove USB memory or turn off the power when the USB memory access indicator is
blinking or when data is being saved or loaded from internal memory. Doing so may damage
the storage medium (USB memory or internal memory) or corrupt its data.
French
ATTENTION
N'enlevez pas un dispositif de mémoire USB et ne coupez pas l'alimentation électrique
lorsque l'indicateur d'accès à la mémoire USB clignote ou lorsque les données sont en train
d'être enregistrées ou chargées à partir d'une mémoire interne. Vous risqueriez
d'endommager le support de stockage (mémoire USB ou mémoire interne) ou les données
qu'il contient.
Procedure
1.
Using the
rotary knob
and
ENTER
, select
Multi-Core Fiber Meas
. The main view screen
appears.
The last measurement project appears.
If you are using this feature for the first time after purchase or if the settings have been initialized,
“NewProject” will appear. “NewProject” is an empty project.
2.
Press
SETUP
and the
File
soft key. Or, press
SETUP
twice. The following screen appears.
Use the rotary knob and ENTER to
select a project file.
The file type is fixed at “*.MPJ.”
Set the load source drive
(Int. Memory, USB Memory).
Set Action to
Load.
Loads the file
The project information is loaded from
the selected file, and the main view
screen appears.
Note
If a project file is loaded from a USB memory device, measurement result files (.SOR extension) will be
saved in a folder in the same folder as the project file (in the USB memory device). The folder will have the
same name as the project file.
Explanation
For firmware versions 2.01 and later, all project files created by AQ1200x/AQ1205x models can be
loaded by AQ1200x/AQ1205xs. However, if a project file contains an invalid measurement condition
even for just one core, the file cannot be loaded. In this situation, an error message will be displayed.
