F²MC-16LX Family, Flash Programmer Yokogawa AF220/221
www.cypress.com
Document No. 002-05108 Rev. *B
16
6
External Key Entry Interface AZ233
This chapter describes how to use two external buttons to control the Flash-Programmer
In order to integrate the Yokogawa Flash-Programmer in an automatic assembly line, two external switch-buttons or
relays connected to EXT.KEX can be used to start a command sequencer.
A command sequence file (*.CSB) is used to define the function.
In case that the signal lines OAK1+ and OAK1- respectively OAK2+ and OAK2- are shortcut the command sequence
LK1 respectively LK2, stored in the CSB-file, is started.
Alternatively two buttons of the keypad can be used, see
This text file consists of two lines. It can be easily edited, e.g.:
my.csb:
LK1,04,E,B,P,R;remark: Erase/BlankCheck/Program/Verify [CRLF]
LK2,01,P;remark: only Program without erasing the chip [CRLF
]
Number of commands
Command Sequence
E
ERASE P
Program
B
Blank Check
R
Read Check (Verify)
Note:
A maximum number of 16 commands can be executed within one sequence.
Figure 19. One Action key
EXT.KEY
