10-4
IM 2560A-01EN
10.3 Configuring the 2560A Ethernet Settings
Turning DHCP On and Off
4.
Turn a
main setting
dial to select DHCP.
The deviation display shows the current DHCP setting.
5.
Turn a
deviation dial
to select ON or OFF.
• When you change the setting, all PRESET indicators turn on.
• If you decide not to change the setting, step 6 is not necessary.
6.
Flip the
PRESET
switch down.
The setting is confirmed. All the PRESET indicators turn off.
Deviation dials (either)
5. Select ON or OFF.
PRESET switch
6. Confirm the
settings.
PRESET indicator
Main setting dials (use any)
4. Select DHCP.
Setting the IP Address, Subnet Mask, and Default Gateway
4.
Turn the four left main setting dials to select IP (IP address), MASK (subnet mask), or GATE
(default gateway).
5.
Turn the right-most
main setting
dial to select the octet number (1 to 4) you want to set.
• The deviation display shows the current octet setting of the IP, MASK, or GATE.
• When octet number 1 is selected, turning the right-most main setting dial to the left shows the previous
SETUP menu. When octet number 4 is selected, turning the right-most main setting dial to the right
shows the next SETUP menu.
6.
Turn the
deviation
dials to set the value of the selected octet.
• When you change the setting, all PRESET indicators turn on.
• If you decide not to change the setting, step 7 is not necessary.
7.
Flip the
PRESET
switch down.
The setting is confirmed. All the PRESET indicators turn off.
Deviation dials
6. Set the value of the
selected octet.
PRESET switch
7. Confirm the settings.
PRESET indicator
Four left main setting dials
4. Select IP, MASK, or GATE.
Right-most main setting dial
5. Select the octet
number you want to
set.
Displays the octet number
8.
Repeat steps 5 through 7 to set the four octets.
9.
Repeat steps 4 through 8 to set IP, MASK, or GATE.
