Yenista Optics TUNICS T100S-HP, User Manual, Page: 17 / 66

Product Presentation
TUNICS T100S-HP User Manual 17
Table 8: MODE Area – Function Keys
SETUP Area Description
The SETUP area is used to enter or change the values of the system operating parameters.
Keys
Table 9: SETUP Area – Keys
OUTPUT Area • STBY / ON : key-lock switch. The product can only be started if the key-lock switch is in
the ON position.
• FC / APC : connector type, protected by a cover bearing the laser warning symbol.
Laser Warning Labels :
2nd
STEP To activate wavelength step-mode (see section Implementing
Step-by-Step Wavelength Scanning, p. 29 ) or sweep-mode
scanning (see section Implementing Continuous Wavelength
Sweep (hop-free), p. 31 ).
1 To disable/enable backlash suppression of the micrometer
screw (see section Turning On/Off Backlash Suppression of the
Micrometer Screw, p. 32 )
.
2 To display the software release.
Remote To change the GPIB address and to activate/deactivate the RS-
232 remote mode: see TUNICS T100S-HP Programming Guide .
FSC To enable the coherence control function (see section Turning
On/Off Coherence Control, p. 32 ).
Remote Switches between remote mode and manual mode (see TUNICS T100S-HP
Programming Guide ).
Key Description
Key Purpose
Numeric keypad Enters a numeric value
← → Corrects a typing error.
ENTER Validates the selection.
. Enters a decimal point.
- Enters a negative value.
Rotary knob Adjusts parameter values.
↑ ↓ Changes the basic increment/decrement applied by the rotary
knob
.
The warning symbol indicates the location of the laser
source. It is accompanied by an explanatory label.
AVOID EXPOSURE
Invisible laser radiation is
emitted from this aperture