Using the OSICS ATN-HP Module
50
OSICS User Manual
6.1.2
OSICS ATN-HP Module Overview
Figure 23: ATN-HP Module – Front and Rear Panels
Front Panel
Optical Connectors
Fiber optic connectors are standard input/output FC/APC type connectors (narrow key).
For more details on the appropriate fiber type and laser power compatibility, see section
OSICS ATN-HP Technical Specifications, p. 49
The
label located on the optical output connector cap indicates the location of the
laser output.
*2
*3
*4
: Total PDL including both FC-APC connectors.
*5
: RL at 1550 nm for SMF & PM15, RL at 1310 nm for PM13.
*6
: PMF: slow axis is aligned to the connector key.
Opening
for air output
Top Notch
Bottom Notch
96-pin VME
Connector
Input Optical Connector
FC/APC type
Retaining Screw
Output Optical Connector
FC/APC type
If you use high power lasers (> 500 mW), please be aware of risks and
procedures needed to handle such high power. Make sure optical
connections are perfectly clean to avoid any dust that will result in
permanent damage of the optical connector (see section
). Warranty will not apply in case of burnt connectors.
The use of optical instruments with this product increases eye hazard.
Do not look directly into the fiber end of an optical cable connected to
any optical output while the device is in use. This may cause permanent
CAUTION
WARNING
