Yenista Optics OSICS, User Manual, Page: 206 / 252

Using the OSICS TLS-50 Module
206 OSICS User Manual
BKR
TL
S-50
AT
N
DFB
EC
L
T100
SLD
SW
T
TLS-A
G
SW
T A
PC
MAI
N
14.1.2 OSICS TLS-50 Module Overview
Figure 156: TLS-50 Module – Front and Rear Panels
Front Panel On LED
This LED indicates that the module is turned on (see section Turning on the OSICS
Multifunction Platform and Accessing the System Status Screen, p. 29 ).
Enable Button
This button enables you to turn on/off the laser inside the module. The green LED of the
button is lit if the optical output is enabled and the power value is displayed in the
System Status screen (see section System Status Screen Description, p. 30 ).
Optical Output Connector
The standard output connector is a FC/APC type connector.
For more details on the appropriate fiber type, see section
OSICS TLS-50 Technical
Specifications, p. 205 .
*1: After warm-up of 60 s.
*2: Over 2 h at a constant temperature.
*3: Enable: on/off. Linewidth from 250 to 1000 MHz depending on the selected frequency mo-
dulation.
*4: Waveshape selection: sinusoidal or triangular.
*5: Tone depth: up to 10 %
*6: RIN within the range 100 MHz–20 GHz measured at 10 dBm output power with RBW = 30 kHz
Opening
for air output
Top Notch
Bottom Notch
96-pin VME
Connector
On LED
Enable Button
Optical Output
Connector
Retaining Screw