S-Series IP PBX Administrator Guide
53
sent to the FXS fort (fax machine).
Fax To Email: sent the fax as an email attachment to the designated email address, which
could be associated to an extension or a custom one.
Note:
Please make sure the sender email addre
ss is correctly configured in “System > Email”.
Outbound Routes
An outbound route works like a traffic cop giving directions to road users to use a predefined route to
reach a predefined destination. Outbound routes are used to specify what numbers are allowed to go
out a particular route. When a call is placed, the actual number dialed by the user is compared with
the dial patterns in each route (from highest to lowest priority) until a match is found. If no match is
found, the call fails. If the number dialed matches a pattern in more than one route, only the rules
with the highest priority in the route are used.
Note:
Yeastar S-Series compares the number with the pattern that you have defined in your route 1. If
matches, it will initiate the call using the selected trunks. If it does not, it will compare the number
with the pattern you have defined in route 2 and so on. The outbound route which is in a higher
position will be matched firstly.
Adjust the outbound route sequence by clicking these buttons
.
Go to
Settings > PBX > Call Control > Outbound Routes
to edit outbound routes.
Please check the outbound route configuration parameters below.
1) Route Name
Give this outbound route a brief name to help you identify it.
2) Dial Patterns
Outbound calls that match this dial pattern will use this outbound route.
Table 6-2 Dial Patterns Description
Patterns
X
Refers to any digit between 0 and 9
Z
Refers to any digit between 1 and 9
N
Refers to any digit between 2 and 9
[###]
Refers to any digit in the brackets, example [123] is 1 or 2 or 3.
Note that multiple numbers can be separated by commas and ranges of
numbers can be specified with a dash ([1.3.6-8]) would match the numbers
1,3,6,7 and 8.
. (dot)
Wildcard. Match any number of anything.
!
Used to initiate call processing as soon as it can be determined that no other
