TG100 User Guide
10/75
Before cleaning the TG100, cut off the power supply.
Environment
Install the Yeastar TG100 in a location that is clean, free from vibration, electric shock, and
temperature/humidity extremes. The operating temperature should be kept below 104°F
(40°C).
Insert/Remove SIM Card
Before powering on TG100, open the box and insert the SIM card on the back panel
directly.
To remove this card, press the button on the left side, the card will pop directly.
Note:
1. The SIM card should be mini-SIM (2FF).
2. Please cut off the power before installing SIM card. You can also log in Web interface to
power this module off separately.
Connect Antenna
TG100 gateway is equipped with antenna connector for the GSM/3G module. The
external antenna should be installed vertically always on a site with a good wireless signal.
You can follow steps below to connect the antenna.
Procedure
1. Connect the external antenna on a site with a good wireless signal, and rotate the
antenna into the antenna connector.
2. Adjust the angle of the antenna.
Connect Ethernet Line
TG100 provides one 10/100M Ethernet port with RJ45 interface and LED indicator. You
can follow steps below to connect the Ethernet line.
Procedure
1. Connect one end of Ethernet line into the Ethernet port of TG100 gateway.
2. Connect the other end of the Ethernet line to a hub, switch, router, LAN or WAN.
3. Check the status of the LED indicator.
Yellow: The port is in 100M mode.
Dark yellow: The port is in 10M mode.
Green: The port if properly connected.
Flashing: Data transmission.
