NeoGate TG Series Installation Guide
15/16
4.4 Make and Receive calls
NeoGate TG Series supports SIP Peer mode. Users should be able to make and receive calls after
configuring VoIP trunking, and Mobile to IP or IP to Mobile routes. Please refer to Administrator’s
Guide for details.
4.5 Reset to Factory Defaults
If you forget the new IP address or the password of admin, or in other cases that you would like
to restore the factory defaults, please reset the device following the below instructions:
Please press the “RESET” button located in the back panel with a paper clip or a pencil tip. You
can see the RUN indicator stops flicker and turns solid. When the RUN indicator turns off, the
button could be released and system begins to reset. During the process, please do not power
off until the RUN indicator become normal which means the reset process is completed.
Note: After resetting, all the configurations made by the admin would be erased.
5. Conclusion
This Installation Guide only explains the installation and basic settings of NeoGate TG Series. For
more functionality and advanced settings of NeoGate TG Series, please refer to the relative
documents as below:
“NeoGate TG Series Datasheet”
“NeoGate TG Series Administrator’s Guide”
[The End]