Yealink Yealink SIP-T42G, Administrator'S Manual

Page: 52 / 898

Administrator’s Guide for SIP-T2 Series/T19(P) E2/T4 Series/CP860 IP Phones
32
To connect a PC or mobile device:
1) Connect one end of the 3.5mm jack cable to the PC/mobile port on the phone, and
connect the other end to the headset jack on the mobile device or the AUX/MIC
jack on the PC.
The initialization process of the IP phone is responsible for network connectivity and
operation of the IP phone in your local network.
Once you connect your IP phone to the network and to an electrical supply, the IP phone
begins its initialization process.
During the initialization process, the following events take place:
Loading the ROM file
The ROM file resides in the flash memory of the IP phone. The IP phone comes from the
factory with a ROM file preloaded. During initialization, the IP phone runs a bootstrap
loader that loads and executes the ROM file.
Configuring the VLAN
If the IP phone is connected to a switch, the switch notifies the IP phone of the VLAN
information defined on the switch (if using LLDP or CDP). The IP phone can then proceed
with the DHCP request for its network settings (if using DHCP).