User Guide for the W56P IP DECT Phone
30
The keypad is unlocked and the icon disappears from the idle screen.
Note
Switching Silent Mode to On/Off
If the silent mode is switched to On, the handset will not ring when receiving an incoming call,
but you can still see the incoming call information on the LCD screen. You can switch the silent
mode to On if you do not want to be disturbed.
To switch the silent mode to On via the handset:
1.
Long press
until the LCD screen prompts “All Ring Tones Off”.
The silent mode is on. The icon appears on the status bar.
To switch the silent mode to Off via the handset:
1.
Long press
again until the LCD screen prompts
“All Ring Tones On”.
The silent mode is off. The icon
disappears from the status bar.
Note
Locating a Handset
You can locate a misplaced registered handset using the base station.
To locate a handset via the handset:
1.
Press
on the base station.
All the handsets that are registered to this base station will ring (paging)
simultaneously and display the IP address of the base station on the LCD screen.
This helps you locate your handset easily.
You can press any key on one of the handsets or press
again on the base station to end
ring (paging).
You can also locate handsets via web user interface at the path
Status
->
Handset&VoIP-
>
Paging Status
.
If the keypad is locked, only the emergency numbers can be dialed out. You must enter the
emergency number continuously and completely. To place emergency calls, you should
configure the emergency numbers in advance. For more information, refer to
Emergency
Numbers
on page
Error! Bookmark not defined.
55
.
When the silent mode is activated, the advisory tones will not be played, regardless of their
settings.
