Yealink T48S Skype For Business Edition, User Manual

Page: 194 / 254

User Guide for the T48S Skype for Business phone
192
The touch screen prompts “Delete selected paging group?”.
4. Tap the
OK
soft key to accept the change.
If you want to delete all paging groups, you can tap the
Delete All
soft key.
Paging list is configurable via web user interface at the path
Directory
->
Multicast IP
.
Receiving RTP Stream
You can configure the phone to receive a Real Time Transport Protocol (RTP) stream from the
pre-configured multicast address(es) without involving SIP signaling. You can specify up to 10
multicast addresses that the phone listens to on the network.
How the phone handles incoming multicast paging calls depends on Paging Barge and Paging
Priority Active parameters configured via web user interface.
Paging Barge
The Paging Barge parameter defines the priority of the voice call in progress. If the priority of
an incoming multicast paging call is lower than that of the active call, it will be ignored
automatically. If Disabled is selected from the pull-down list of Paging Barge, the voice call in
progress will take precedence over all incoming multicast paging calls. Valid values in the
Paging Barge field:

1 to 10
: Define the priority of the active call, 1 is with the highest priority, while 10 is with
the lowest.

Disabled
: The voice call in progress will take precedence over all incoming paging calls.
Paging Priority Active
The Paging Priority Active parameter decides how the phone handles incoming multicast
paging calls when there is already a multicast paging call on the phone. If enabled, the phone
will ignore incoming multicast paging calls with lower priorities, otherwise, the phone will
answer incoming multicast paging calls automatically and place the previous multicast paging
call on hold. If disabled, the phone will automatically ignore all incoming multicast paging calls.