Yealink T48G, Administrator'S Manual

Page: 143 / 622

Phone Customization
123
Expansion Module Page Tips Configuration
The following table lists the parameters you can use to configure expansion module page tips.
Parameter expansion_module.page_tip.blf_call_in.enable <y0000000000xx>.cfg
Description
It enables or disables the page switch key LED on the expansion module to indicate
when BLF monitored user receives an incoming call on the non-current pages.
Note: It is only applicable to EXP50 expansion modules connected to the T54S/T52S IP
phones.
Permitted
Values
0-Disabled
1-Enabled
Default 1
Parameter expansion_module.page_tip.blf_call_in.led
<y0000000000xx>.cfg
Description
It configures the page switch key LED status on the expansion module when BLF
monitored user receives an incoming call on the non-current pages.
This value uses the same macro action string syntax as an Enhanced DSS key.
If it is left blank, the default value takes effect.
Example:
expansion_module.page_tip.blf_call_in.led = $LEDr300o300$
It means an infinite loop for page switch key LED status: glow red for 300ms and then
be in the off state for 300ms.
Note: It works only if “expansion_module.page_tip.blf_call_in.enable” is set to 1
(Enabled). It is only applicable to EXP50 expansion modules connected to the
T54S/T52S IP phones.
Permitted
Values
String
Default $LEDr300o300$
Time and Date
Yealink IP phones maintain a local clock. You can choose to get the time and date from SNTP (Simple
Network Time Protocol) time server to have the most accurate time and set DST (Daylight Saving Time) to
make better use of daylight and to conserve energy, or you can set the time and date manually. The time
and date can be displayed in several formats on the idle screen.
Topics
Time Zone
NTP Settings