Yealink SIP-T54S, Administrator'S Manual

Page: 72 / 1126

Administrator’s Guide for SIP-T2 Series/T19(P) E2/T4 Series/T5 Series/CP860/CP920 IP Phones
46
DHCP
DHCP (Dynamic Host Configuration Protocol) is a network protocol used to dynamically
allocate network parameters to network hosts. The automatic allocation of network parameters
to hosts eases the administrative burden of maintaining an IP network. IP phones comply with
the DHCP specifications documented in
RFC 2131 . If using DHCP, IP phones connected to the
network become operational without having to be manually assigned IP addresses and
additional network parameters.
Procedure
DHCP can be configured using the following methods.
Central Provisioning
(Configuration File)
<MAC>.cfg
Configure DHCP on the IP phone.
Parameter:
static.network.internet_port.type
Web User Interface
Configure DHCP on the IP phone.
Navigate to:
http://<phoneIPAddress>/servlet?p=network
&q=load
Phone User Interface
Configure DHCP on the IP phone.
Details of Configuration Parameter:
Parameter Permitted Values Default
static.network.internet_port.type 0 or 2 0
Description:
Configures the Internet port type for IPv4.
0
-DHCP
2
-Static IP Address
Note
: It works only if the value of the parameter “static.network.ip_address_mode” is set to
0 (IPv4) or 2 (IPv4 & IPv6). If you change this parameter, the IP phone will reboot to make
the change take effect.
Web User Interface:
Network->Basic->IPv4 Config
Phone User Interface:
Menu->Advanced (default password: admin) ->Network->WAN Port->IPv4