Basic Call Features
109
conference.
8.
Repeat steps 5 to 7 until you have added all intended parties.
The procedures to set up a network conference call on specific servers may be different from
introduced above. Contact your system administrator for more information.
Call Park/Retrieve
You can use call park feature to place a call on hold, and then retrieve the call from another
phone in the system (for example, a phone in another office or conference room). You can park
an active call by pressing the
Park
soft key or call park key (if configured) on the phone. If the
call is parked successfully, there is a voice prompt confirming that the call was parked. You can
retrieve the parked call by pressing the
Retrieve
soft key or the retrieve park key (if configured).
If the parked call is not retrieved within a period of time defined by the system, the phone performing
call park will receive the call back.
Note
The IP phone supports call park feature under the following modes:
FAC mode
: park the call to the local extension or a desired extension through dialing the
park code.
Transfer mode
: park the call to shared parking lot through performing a blind transfer to
a call park number (call park code).
You can also configure a call park key and retrieve park key.
To configure a call park key via phone user interface:
1.
Press
Menu
->
Features
->
DSS Keys
.
2.
Select the desired line key.
3.
Press or , or the
Switch
soft key to select
Key Event
from the
Type
field.
4.
Press or , or the
Switch
soft key to select
Call Park
from the
Key Type
field.
5.
Press or , or the
Switch
soft key to select the desired line from the
Account ID
field.
6.
(Optional.) Enter the string that will appear on the LCD screen in the
Label
field.
7.
(Optional.) Enter the call park code in the
Value
field.
8.
Press the
Save
soft key to accept the change or the
Back
soft key to cancel.
If the call park code is already configured for the
Park
soft key, you don’t need to configure it
when configuring a call park key.
To configure a retrieve park key via phone user interface:
1.
Press
Menu
->
Features
->
DSS Keys
.
Call park is not available on all servers. Contact your system administrator for more information.
Summary of Contents for SIP-T40P
Page 1: ......
Page 12: ......
Page 132: ...User Guide for the SIP T40P IP Phone 120...
Page 185: ...Appendix 173 Appendix B Menu Structure...
