Appendix
195
Parameter
Permitted Values
Descriptions
Web Setting Path
flash)
1-Enabled ( power indicator LED fast flashes
(500ms) red)
The default value is 0.
If it is set to 0, the status of the power
indicator LED is determined by the value of
the parameter
“phone_setting.common_power_led_enabl
e”.
phone_setting.talk_and_dial_power_led_enable =
(not applicable to CP860 IP phones)
0 or 1
It enables or disables the power indicator
LED to be turned on when the phone is busy.
For SIP-T2xP/T19P IP phones:
0-Disabled (power indicator LED is off)
1-Enabled ( power indicator LED is solid
green)
The default value is 1.
For SIP-T4X IP phones:
0-Disabled (power indicator LED is off)
1-Enabled (power indicator LED is solid red)
The default value is 0.
If it is set to 0, the status of the power
Features->Power LED->Talk/Dial Power
Light On
Summary of Contents for SIP-T2XP
