User Guide for the SIP-T27G IP Phone
100
Placing Calls
You can place a call in one of three ways using your SIP-T27G IP phone:
Using the handset
Using the speakerphone
Using the headset
You can also dial the number first, and then choose the way you want to speak to the other
party.
You can also search and dial a contact from local directory, remote phone book or call history.
For more information, refer to
and
on page
During a call, you can alternate between Speakerphone, Headset, and Handset modes by
pressing the Speakerphone key, the HEADSET key, or by picking up the handset.
The call duration of the active call and far-site’s information (name or phone number) are visible
on the LCD screen. In the figure below, the call to “Tom” (the phone number: 1007) has lasted 5
seconds.
To place a call using the handset:
1.
Pick up the handset.
2.
Enter the desired number using the keypad.
3.
Press , , or the
Send
soft key.
The # key is configured as a send key by default. You can also set the * key as the send key, or
set neither. For more information, refer to the
Note
You can also dial using the SIP URI or IP address. To obtain the IP address of a phone, press the
OK
key when the phone is idle. The maximum length of SIP URI or IP address length is 32
characters. For example, SIP URI: [email protected], IP: 192.168.1.15 or 192*168*1*15.
Your phone may not support direct IP dialing. Contact your system administrator for more
information.
