Yealink SIP-T19 E2 T4 Series, Administrator'S Manual

Page: 308 / 981

Administrator’s Guide for SIP-T2 Series/T19(P) E2/T4 Series/T5 Series IP Phones
286
Parameters
Permitted
Values
Default
None
Phone User Interface:
None
dialplan.digitmap.interdigit_short_timer
Refer to
the
following
content
3
Description:
Configures the timeout interval (in seconds) for any string of digit map.
The IP phone will wait this many seconds before matching the entered digits to the dial plan
and placing the call.
Valid values are:

Single configuration (configure a specific value for the timer letter “T” for all strings
with “T” of the digit map)
Example
:
dialplan.digitmap.interdigit_short_timer = 5
If the value of the parameter “dialplan.digitmap.string” is set to <[2-9]x:86>3.T|0T, the IP
phone will wait 5 seconds before matching the entered digits to this dial plan and placing
the call.

Distribution configuration (configure a string of positive integers separated by “|” for
each string of the digit map in the corresponding position)
If there are more digit maps than timeout values, the last timeout is applied to the extra digit
map. If there are more timeout values than digit maps, the extra timeout values are ignored.
Example
:
dialplan.digitmap.interdigit_short_timer = 4|5|3|6|2|1
If the value of the parameter “dialplan.digitmap.string” is set to
<[2-9]x:86>3.T|2T|1xxT|0x.!|[2-9]11T, 4 is applied to the “<[2-9]x:86>3.T” digit map, 5 is
applied to “2T” digit map, 3 is applied to “1xxT” digit map, 6 is applied to “0x.!” digit map, 2
is applied to the “[2-9]11T” digit map, the last digit 1 is ignored.
Note:
It works only if the value of the parameter “dialplan.digitmap.enable” or
“account.X.dialplan.digitmap.enable” is set to 1 (Enabled). The value configured by the
parameter “account.X.dialplan.digitmap.interdigit_short_timer” takes precedence over that
configured by this parameter.
Web User Interface:
None
Phone User Interface:
None