Yealink One Talk CP960, Administrator'S Manual

Page: 84 / 533

Phone Provisioning
81
Default
Blank
[1]
X is an activation code ID. X=1-50.
[2]
If you change this parameter, the phone will reboot to make the change take effect.
PIN Code Provisioning Settings Configuration
You can enable the users to trigger phones to perform provisioning by dialing a PIN code.
For more information on PIN code provisioning, refer to Yealink SIP IP Phones Auto Provisioning Guide .
The following table lists the parameters you can use to configure settings for PIN code provisioning.
Parameter phone_setting.retain_pin.enable <y0000000000xx>.cfg
Description It enables or disables the phone to save the entered PIN code.
Permitted
Values
0-Disabled
1-Enabled, the phone saves the entered PIN code and users do not need to enter again.
Default 1
Related
Parameters
static.custom_mac_cfg.url
Viewing Configurations Configured via Different Provisioning Methods
On the web user interface, you can click the question mark "?" after each configuration to see its detailed inform-
ation.
From the detailed information, you can do the following:
l
Check whether settings you make using a higher priority provisioning method override settings made using a
lower priority provisioning method.
l
Reset a configuration to factory setting.
l
See the default value of the desired configuration.
The table lists each parameter in the detailed information.
Parameter Description
Description Description of this configuration item
CFG Configuration The parameter in the configuration file
Valid Value The permitted values
Configuration Source Values
(This appears only when the para-
meter “static.auto_pro-
vision.custom.protect” is set to 1.)
Web/Local:
(It appears only for a
non-static parameter.)
Not Applicable: the value is not changed via phone or
web user interface.
Specific value: the value is changed via phone or web
user interface. Click Reset to reset the value.
Config:
(It appears only for a
non-static parameter.)
Not Applicable: the parameter is not changed in the con-
figuration files.
Specific value: the parameter is changed in the con-
figuration files. Click Reset to reset the value.
Static:
(It appears only for a
Not Applicable: the parameter is not configured in any
provisioning method.