Yealink MeetingSpace VC800, Administrator'S Manual

Page: 196 / 295

Administrator’s Guide for Yealink VC800 Video Conferencing System
182
Parameter Description Configuration Method
Note
: If you change this parameter,
the system will reboot to make the
change take effect.
To configure MTU via web user interface:
1.
Click on
Network
->
Advanced
.
2.
In the
MTU
block, enter the desired value in the
Video MTU
field.
3.
Click
Confirm
to accept the change.
A dialog box pops up to prompt that the settings will take effect after a reboot.
4.
Click
Confirm
to reboot the system immediately.
To configure MTU via the remote control:
1.
Select
More
->
Setting
->
Advanced
(default password: 0000) ->
Advanced Network
.
2.
Enter the desired value in the
Video MTU(1000-1500)
field.
3.
Select
Save
, and then press to accept the change.
The display device prompts “Reboot now?”.
4.
Select
OK
, and then press to reboot the system immediately.
Dual-Stream Protocol
To enhance the process of communicating with others over video, the dual-stream protocol
provides the ability to share content from a computer, such as video clips or documentation.
Both the video and the documentation can be transmitted to the far site simultaneously, thus
meeting the requirements of different conference scenarios, such as training or medical
consultation.
The Yealink video conferencing system supports the standard H.239 protocol and BFCP (Binary
Floor Control Protocol). H.239 protocol is used when sharing content with the far site in H.323
calls. BFCP protocol is used when sharing content with the far site in SIP calls. Before enabling
the desired protocol, ensure that the protocol is supported and enabled by the far site you wish