Yealink MeetingSpace VC500, Administrator'S Manual

Page: 80 / 281

Administrator’s Guide for Yealink VC800&VC500 Video Conferencing System
64
4.
Click
Confirm
to accept the change.
To configure SIP IP call via the remote control:
1.
Select
More
->
Setting
->
Advanced
(default password: 0000)->
SIP IP Call
.
2.
Check the
SIP IP Call
checkbox.
3.
Select
Save
, and then press to accept the change.
Configuring H.323 Settings
Yealink VC800/VC500 video conferencing systems support H.323 protocol. If your network uses
a gatekeeper, you can register an H.323 account for the system, and specify its H.323 name and
extension. This allows others to call the system by entering the H.323 name or extension instead
of the IP address.
H.323 settings parameters on the system are described below:
Parameter Description Configuration Method
H.323 Protocol
Enables or disables the H.323 protocol.
Default:
Enabled.
Note:
Only when it is set to Enabled, can
H.323 account be registered. When it is
set to Enabled on both sites, the
VC800/VC500 can call the far site by
dialing an IP address directly.
Remote Control
Web User Interface
H.323 Account
Enables or disables the H.323 account.
Default:
Enabled
If it is set to disabled, the system cannot
place or receive calls with the H.323
protocol.
Remote Control
Web User Interface
H.323 Name
Specifies the name that gatekeepers and
gateways use to identify this system. You
can make point-to-point calls using
H.323 names if both system are
registered to a gatekeeper.
Default:
blank
Remote Control
Web User Interface
H.323 Extension
Specifies the extension that gatekeepers
and gateways use to identify this system.
Default:
blank
Note:
Users can place point-to-point
calls using the extension if both systems
are registered with a gatekeeper.
Remote Control
Web User Interface