Yealink MeetingSpace VC500, Administrator'S Manual

Page: 55 / 281

Configuring Network
39
To configure the 802.1X via the remote control:
1.
Select
More
->
Setting
->
Advanced
(default password: 0000) ->
Advanced Network
.
2.
Select the desired mode from the pull-down list of
802.1x Mode
.
3.
Select
Save
, and then press to accept the change.
The display device prompts “Reboot now?”.
4.
Select
OK
, and then press to reboot the system immediately.
Configuring the System for Use with a Firewall
A firewall protects an organization’s IP network by controlling data traffic from outside the
network. Unless the firewall is designed to work with video conferencing equipment, you must
configure the firewall to allow incoming and outgoing traffic to the VC800/VC500 system
through the reserved ports. Users placing calls through a firewall to systems may experience
one-way audio or video if the firewall is not properly configured.
Call Setup and Media Ports
To place calls to remote systems through the firewall, you must configure your firewall to allow
incoming and outgoing traffic to the system through the following:
Description Port Range Port Type
Gatekeeper 1719 UDP
H.323 call negotiation 1720 TCP
SIP call negotiation 5060 UDP
SIP call negotiation if TCP signaling is
enabled for SIP calls.
5060 TCP
TLS signaling in SIP calls if TLS signaling is
enabled.
5061 TLS
Reserved ports of the system.
For more information, refer to Restricting
50000-50499
(default range)
TCP/UDP