Yealink CPE80, Administrator'S Manual

Page: 266 / 321

Administrator’s Guide for Yealink VC110 Video Conferencing Endpoint
250
Parameter Description Configuration Method
Note:
It can only be configured
when the user mode is enabled. The
endpoint supports ASCII characters
32-126(0x20-0x7E) in passwords.
You can leave the password blank.
To configure user mode via web user interface:
1.
Click on
Security
->
Security
.
2.
Select
User
from the pull-down list of
User Type
.
3.
Select
Enabled
from the pull-down list of
User Mode
.
4.
Configure a password or leave it blank in the
User Password
field.
5.
Click
Confirm
to accept the change.
Administrator Password
The default enabled user type is administrator. Users can log into the web user interface and
access the “Advanced” menu with administrator privilege by default. The default administrator
password is “0000” and can be only changed by an administrator. For security reasons, the
administrator should change the default administrator password as soon as possible. The
endpoint supports ASCII characters 32-126(0x20-0x7E) in passwords.
Administrator password parameters on the endpoint are described below:
Parameter Description Configuration Method
User Type
Specifies the user type.
Default:
Administrator
Note:
To configure a new
administrator password, you need to
select Administrator for this
parameter.
Web User Interface
Old Password
Enters the old administrator
password.
Note:
The default administrator
password is “0000”.
Remote Control
Web User Interface