Yealink CPE80, Administrator'S Manual

Page: 230 / 321

Administrator’s Guide for Yealink VC110 Video Conferencing Endpoint
214
The web user interface prompts “Clear the camera data?”.
3.
Click
Confirm
to accept the change.
To clear all camera preset positions via the remote control:
1.
Select
Menu
->
Video & Audio->Camera General Settings
.
2.
Select
Clear Preset Position
.
3.
Pres
s OK
to accept the change.
Far-end Camera Control
Local video is displayed on the display device of the far site during a call. For the best view, you
can enable the Far Control of Near Camera feature to allow the far site to control the focus and
angle of the local camera. You can also specify whether the far site is allowed to store and use
the local camera presets.
Far control of the near camera parameters are described below.
Parameter Description Configuration Method
Not FECC in
call(0~300s)
Configures the duration time (in
seconds) when far site cannot
control the local camera during a
call.
Default:
15
If it is set to 15, the far site is not
allowed to control the local camera
in the first 15 seconds of the call.
Web User Interface
Far Control Near
Camera
Enables or disables the far site to
control the local camera.
Default:
Enabled
Remote Control
Web User Interface
Far Set of Camera
Presets
Enables or disables the far site to
create presets for the local camera.
Default:
Disabled
Note
: It only works if the value of
the “Far Control Near Camera” is set
to Enabled.
Remote Control
Web User Interface
Far Move to
Camera Presets
Enables or disables the far site to
point local camera at pre-defined
locations.
Default:
Disabled
Note
: It only works if the value of
the “Far Control Near Camera” is set
Remote Control
Web User Interface