Yealink CP920, User Manual

Page: 86 / 176

User Guide for the CP920 HD IP Conference Phone
76
Placing Calls
You can tap the off-hook key either before or after entering the number to place a call. You can
also dial an entry from local directory, favorite directory, remote phone book or call history. For
more information, refer to
Contact Management on page 40 and Call History Management on
page 55 .
The call duration and far-site’s information (name and phone number) are visible on the LCD
screen. In the figure below, the call to “Bob” (the phone number: 0217) has lasted 6 seconds.
Placing a Call
To place a call:
Do one of the following:
- Tap to obtain a dial tone.
Enter the desired number using the keypad.
Tap , , or the
Send
soft key.
- Enter the desired number using the keypad.
Tap , , or the
Send
soft key.
The
#
key is configured as a send key by default. You can also set the
*
key as the send key, or
set neither. For more information, refer to the Key As Send on page 34 .
Note
Placing multiple calls
The CP920 IP conference phone can handle multiple calls at a time. However, only one active
call (the call that has audio associated with it) can be in progress at any given time.
To place multiple calls:
You can have more than one call on your CP920 IP conference phone. To place a new call
during an active call, do one of the following:
-
Tap . The active call is placed on hold.
You can also dial using the SIP URI or IP address. To obtain the IP address of a phone, tap the
OK
key when the phone is idle. The maximum length of SIP URI or IP address length is 32
characters. For example, SIP URI: 3606@sip.com, IP: 192.168.1.15 or 192*168*1*15.
Your phone may not support direct IP dialing. Contact your system administrator for more
information.