YEACOMM P11K User Manual
Thank you for choosing Yeacomm YF-P11K 4G wireless router Wifi
Kit, please read and keep the user manual carefully.
1. Main Technology Parameters
●
Working temps : -30
℃
-- +60
℃
●
Relative humidity: 5%--95%
●
Working frequency :
LTE: B1/2/3/5/7/8/20/38/40
LTE: B1/2/3/5/7/8/28/38/39/40/41(Optional)
●
Power supply : input AC :100V~240V
，
50Hz~60Hz
Output DC: 15V, 1000mA
●
Size: 252mm*112mm*58mm (Outdoor Unit)
105mm* 95mm*20mm (Indoor AP)
●
Rate of uplink and downlink: LTE(Cat 4) 150Mbps/DL
；
50Mbps/UL
2. Product Interface and Indicator
2.1 Product interface
2.11 Outdoor router interface introduction
2.12 Indoor AP interface introduction
2.2 Indicator
2.21 Outdoor unit indicator
Type
Status
Description
RF
All off
no signal (the signal status can be
checked in the terminal configuration
page)
One on
Signal is poor
Two on
Signal is moderate
Three on
Signal is good
All on
Signal is very good
SYS
Off
Power abnormal, the router power off
On
Power normal, the router power on
SIM
Off
No SIM or can not detect SIM card
On
Device read the SIM normally
ETH
Off
Device doesn't connect to PC
On
Device connects to PC
RUN
Off
Device is not running
On
Device is running
2.22 Indoor unit indicator
Indicator
type
status
Description (from left to right )
POWER
Off
Power abnormal, the router power off
On
Power normal, the router power on
SIGNAL
Off
no signal
(the signal status can be checked in the
terminal configuration page)
Red
The signal is poor
Yellow
Signal is moderate
Green
Signal is good
WLAN
Off
WiFi off
Flicker
WiFi on and has data transmission
DATA
Off
Outdoor unit do not connect with
indoor unit .
On
Outdoor unit connects with indoor
unit .
WAN
Off
Outdoor unit does not connect with
indoor unit .
Light
Outdoor unit connects with indoor unit
LAN1/
LAN2
Off
Do not connect with PC
Light
Connect with PC correctly
3. Installation
3.1 Insert the sim card as below. When you hear a clicking sound, it
means that the USIM card has been installed successfully.
3.2 Connect the wan port of the indoor AP to the outdoor cpe router’s
POE port by Cate5e cable.
3.3 Place the outdoor unit outside in open space, the front panel face
to the base station. Make sure the unit is fixed well.
