YATO YT-82185, Original Instructions Manual

Page: 13 / 92

13
O R I G I N A L I N S T R U C T I O N S
GB
PRODUCT OVERVIEW
The band saw is a handheld power tool, which, by means of a blade formed into an endless loop, can cut pipes, tubes, and other
metal sections. The band saw features a base that makes cutting easy and safe. As the correct, reliable, and safe operation of
the tool depends on its proper use:
Read and keep the entire manual before the fi rst use of the tool.
The tool supplier shall not be liable for any damage resulting from failure to comply the safety instructions and recommendations
specifi ed in this manual.
ACCESSORIES
The tool is delivered complete and requires preparation for operation. A saw blade and a base are supplied with the product.
TECHNICAL DATA
Parameter Units Value
Catalogue No. YT-82195
Rated voltage [V~] 220 – 240
Rated frequency [Hz] 50
Rated power [W] 1100
Saw blade speed [m/s] 0.7 – 2.4
Saw blade specifi cations
- length
[mm] 1140
- height [mm] 12.7
- thickness [mm] 0.6
- number of teeth per inch of blade length (TPI) - 14
Cutting range (H x W) [mm] 127 x 127
Weight [kg] 6.6
Protection class - II
Ingress protection rating - IP20
Noise level
- sound pressure, LpA ± K
[dB(A)] 89 ± 3
- sound power, LwA ± K [dB(A)] 100 ± 3
Vibration level, ah ± K (metal/wood cutting) [m/s
2
] 6.62 ± 1.5 / 6.08 ± 1.5
GENERAL SAFETY CONDITIONS
NOTE! Get acquainted with all the instructions below. Failure to observe them may lead to an electric shock, fi re or injuries. The
notion of electric tool used in the instructions applies to all the tools which are powered with electric current, both wire tools and
wireless ones.
OBSERVE THE FOLLOWING INSTRUCTIONS
Place of work
The place of work must be properly illuminated and clean. Disorder and poor illumination may be a cause of accidents.
Do not work with electric tools in explosive environments, or those which contain infl ammable liquids, gases or vapours.
Electric tools generate sparks, which may cause a fi re in case of contact with infl ammable gases or vapours.
Do not allow children and outsiders to the place of work. A lack of concentration may result in a loss of control over the tool.
Electric safety
The plug of the power supply cable must fi t the mains socket. Do not modify the plug. Do not use any adapters what-
soever in order to adapt the plug to the socket. Unmodifi ed plug which fi ts the socket reduces the risk of an electric shock.
Avoid contact with grounded surfaces, such as pipes, heaters and refrigerators. Grounding of the body increases the risk
of an electric shock.
Do not expose electric tools to precipitation or humidity. Water and humidity which gets into the electric tool increases the
risk of an electric shock.
Do not overload the power supply cable. Do not use the power supply cable in order to carry the tool or to connect and
disconnect the plug from the mains socket. Avoid contact of the power supply cable with heat, oils, sharp tools and