4.
Mount the screws again.
After installation the interface module is automatically recognized and
can be configured.
1.
Remove the screws.
2.
Push the holding plate from the lugs. Use a screwdriver by
inserting it gently between the housing and holding plate.
3.
Pull the interface module out of the device.
4.
Reinstall the cover plate.
4.3 Commissioning
CAUTION!
– Before commissioning the device must be brought to
room temperature.
– At condensation the device must be absolutely dry
before connected to power.
– To avoid overheat during operation the device must not
be laid open to direct sun light.
– After opening the control cabinet or desk, there are
parts with possible dangerous voltage available.
– For all signal connections only screened cables are
permitted.
– Signal cables must not be let within the same cable
shaft as high voltage cables.
4.3.1 VIPA Startup-Manager
As soon as the Touch Panel is provided by power supply, the
VIPA
Startup-Manager
will be loaded.
Demounting
VIPA HMI
Deployment under Windows CE 6.0 Prof.
Commissioning> VIPA Startup-Manager
HB160 | TP-ECO | 62E-MGC0 | GB | 16-02
48
