2.
Gradually take up the slack in the wires and hoist the drive after the wires are stretched tight.
3.
Lower the drive when ready to install in the enclosure panel. Stop lowering the drive when it is near the floor, then slowly
begin lowering the drive again very slowly until the drive is placed correctly.
Harmonic Filter Module
1.
Pass wire through the holes of all four hanging brackets.
Suspending angle:
50
°
or greater
Figure 2.10 Harmonic Filter Module Suspension Using Wires and Hanging Brackets (EUJ7118
oo
.
o
)
2.
Gradually take up the slack in the wires and hoist the harmonic filter module after the wires are stretched tight.
3.
Lower the harmonic filter module when ready to install in the enclosure panel. Stop lowering the harmonic filter module
when it is near the floor, then slowly begin lowering the harmonic filter module again very slowly until the harmonic filter
module is placed correctly.
u
Digital Operator Remote Usage
n
Remote Operation
The digital operator mounted on the drive can be removed and connected to the drive using a remote control extension cable
up to 3 m long to facilitate operation when the drive is installed in a location where it cannot be easily accessed.
The digital operator can also be permanently mounted remote locations such as panel doors using a remote control extension
cable and an installation support set (depending on the installation type).
Note:
Refer to Drive Options and Peripheral Devices on page 458
for information on remote control extension cables and installation support
sets.
S/N : J007XE273710001
Operator
Drive
Communication Cable Connector
Comm Port
Figure 2.11 Communication Cable Connection
2.2 Mechanical Installation
64
YASKAWA ELECTRIC SIEP C710636 04D U1000 Industrial MATRIX Drive Technical Manual
Summary of Contents for U1000 iQpump Drive
Page 705: ......
