5.12 U: Monitor Parameters
YASKAWA ELECTRIC
SIEP C710616 30B YASKAWA AC Drive T1000A Technical Manual
263
P
a
ra
me
te
r D
e
ta
ils
5
5.12 U: Monitor Parameters
Monitor parameters let the user view various aspects of drive performance using the digital operator display. Some
monitors can be output from terminals FM and AM by assigning the specific monitor parameter number (U
-
) to
H4-01 and H4-04.
Refer to H4-01, H4-04: Multi-Function Analog Output Terminal FM, AM Monitor Selection on
for details on assigning functions to an analog output.
u
U1: Operation Status Monitors
Status monitors display drive status data such as output frequency and output current. Refer to
for a complete list of U1-
monitors and descriptions.
u
U2: Fault Trace
These monitor parameters are used to view the status of various drive aspects when a fault occurs.
This information is helpful for finding out why a fault occurred. Refer to
for a complete list
of U2-
monitors and descriptions.
U2-
monitors are not reset when the drive is initialized.
Refer to o4-11: U2, U3 Initialization on page 249
instructions on how to reset these monitor values.
Note:
Fault trace (i.e., the fault history) is not kept when CPF00, CPF01, Uv1, Uv2 occur.
u
U3: Fault History
These parameters display faults that have occurred during operation as well as the drive operation time when those faults
occurred. Refer to
for a complete list of U3-
monitors and descriptions.
U3-
monitors are not reset when the drive is initialized.
Refer to o4-11: U2, U3 Initialization on page 249
instructions on how to reset these monitor values.
Note:
Fault trace (i.e., the fault history) is not kept when CPF00, CPF01, Uv1, Uv2 occur.
u
U4: Maintenance Monitors
Maintenance monitors show:
• Runtime data of the drive and cooling fans, and number of Run commands issued
• Maintenance data and replacement information for various drive components
• kWh data
• Highest peak current that has occurred and output frequency at the time the peak current occurred
• Motor overload status information
• Detailed information about the present Run command and frequency reference source selection
Refer to U4: Maintenance Monitors on page 418
for a complete list of U4-
monitors and descriptions.
u
U5: PID Monitors
These monitors display various aspects of PID control.
Refer to PID Block Diagram on page 129
for details on how
these monitors display PID data.
has a complete list of U5-
monitors and descriptions.