YASKAWA SGDV SERVOPACK, User Manual

Page: 321 / 398

www.dadehpardazan.ir 88594014-15
8 Monitor Displays (Un

)
8.7.2 Interpreting Output Signal Display Status
8-10
8.7.2
Interpreting Output Signal Display Status
The status of allocated signals is displayed on the 7-segment display on the panel operator.
Output terminals correspond to LED numbers as shown in the following table.
• When the output signal is in OFF status, the top segment (LED) is lit.
• When the output signal is in ON status, the bottom segment (LED) is lit.
Note: Input signals use the following circuit configuration.
• OFF: Transistor OFF
• ON: Transistor ON
Example
8.7.3
Output Signal Display Example
Output signals are displayed as shown below.
• When the ALM signal is OFF
Display LED
Number
Output Terminal Name
Signal Name
(Factory Setting)
1
CN1-31
,
-32
ALM
2
CN1-25, -26 /COIN or /V-CMP
3
CN1-27,
-
28
/TGON
4 CN1-29, -30 /S-RDY
5 CN1-37 ALO1
6 CN1-38 ALO2
7 CN1-39 ALO3
8

Reserved
4 3 2 1
Top: OFF
Bottom: ON
Number 6 7 8 5
Analog
ON: Transistor ON
The top segment of
number 1 is lit.
7 6 8 5 4 3 2 1
Analog