13.4 Utility Function (Fn
) Operations on the Panel Operator
13.4.4 Jog Program (Fn004)
13-15
13
Panel Displays and Panel Operator Pr
ocedur
es
13.4.4
Jog Program (Fn004)
Refer to the following section for information on this utility function other than the procedure.
Step
Panel Display after
Operation
Keys
Operation
1
Press the
MODE/SET
Key to enter Utility Function
Mode.
2
Press the
UP
Key or
DOWN
Key to display
Fn004
.
3
Press the
DATA/SHIFT
Key for approximately one sec-
ond. The display shown on the left will appear.
4
Press the
MODE/SET
Key to turn ON the servo. The
display shown on the left will appear.
5
Press the
UP
Key or
DOWN
Key according to the initial
movement direction of the operation pattern. The
operation will start after the preset waiting time.
Additional Information
•
Press the
MODE/SET
Key during operation. The
servo will turn OFF and the Servomotor will stop.
•
Press the
DATA/SHIFT
Key for approximately one
second during operation. The display shown for step
2 will appear again.
6
–
When program jogging has been completed,
End
will
flash on the display, and then the display shown on the
left will appear again.
Additional Information
•
Press the
MODE/SET
Key during operation to turn
OFF the servo and return to the display shown for
step 3.
•
Press the
DATA/SHIFT
Key for approximately one
second during operation to return to the display
shown for step 2.
7
Turn the power supply to the SERVOPACK OFF and ON again after you finish program operation.
MODE/SET
DATA/
MODE/SET
DATA/
MODE/SET
DATA/
MODE/SET
DATA/
MODE/SET
DATA/
