2-14
183523-1CD
183523-1CD
2
Installation
2.3 Positioner Installation
RM2-755-RDR Postioner
Positioner Installation and Lagging Requirements
• The customer is responsible for reviewing the data in
to determine all equipment lagging requirements.
• The customer is responsible for determining the adequacy of the
foundation in the area where the proposed Positioner equipment will
be located.
• If the foundation is found to be inadequate for the proposed
equipment, the customer will be responsible for installing or
subcontracting the installation of a suitable foundation for the
proposed equipment.
• Upon receipt of the Positioner supplied equipment, the customer is
responsible for supplying the recommended lagging required based
on section
. The customer is responsible for
providing the labor and material for installing the lagging per
recommendations.
Equipment Anchoring
• The Customer or designated Contractor shall provide and install all
required Hilti Anchors or equivalent.
• For the applications listed with Kwik Bolt II Expansion type Anchors,
other proposed manufacturers' strength characteristics must meet
the equivalent Hilti strength characteristics.
• Stud anchors shall extend above the Nut no more than 25mm.
• The Customer or designated contractor shall use a minimum of 5/8”
HVA Chemical Style anchors when choosing anchors for the
equipment being installed.
• The customer or designated contractor shall use the approved
anchors of the lengths consistent with the minimum 5/8” HVA
Chemical Style anchor.
• The Hilti HVA Chemical Style anchors specified are Standard HAS
Rod Material ASTM Type A36 as a minimum for Mechanical
Properties required. Standard HAS-E Rod Material ISO 898
Class 5.8 or Super HAS Rod Material ASTM A193, Grade B7 may
be substituted as required.
NOTICE
The data in this document is to assist in the installation of equipment.
Before installing any equipment evaluate the floor to determine if it is
within the requirements of the equipment.
34 of 104
