8-12
155507-1CD
RE-CSO-A037
DX100
8 Parameter
8.3 Mode Operation Setting Parameters
8.3
Mode Operation Setting Parameters
These parameters set various operations in the teach mode or remote
mode.
Some parameters can be set through {SETUP}
{TEACHING COND} or
{OPERATE COND}.
8.3.0.1 S2C195:
SECURITY
MODE
WHEN CONTROL POWER SUPPLY IS
TURNED ON
The operation level when the control power supply is turned ON is set.
8.3.0.2 S2C196:
SELECTION
OF CARTESIAN/CYLINDRICAL
This parameter specifies whether the cartesian mode or cylindrical mode
is affected when cartesian/cylindrical mode is selected by operation
(coordinate) mode selection at axis operation of programming pendant.
This specification can be done on the TEACHING CONDITION window.
8.3.0.3 S2C197: COORDINATE SWITCHING PROHIBITED
This parameter prohibits switching coordinates during JOG operation by
the programming pendant.
8.3.0.4 S2C198: EXECUTION UNITS AT “FORWARD” OPERATION
This parameter specifies the execution units at step mode of “FORWARD”
operation by the programming pendant.
0
: Operation Mode
1
: Editing Mode
2
: Management Mode
0
: Cylindrical mode
1
: Cartesian mode
0
: Switching permitted for tool coordinates and user coordinates
1
: Switching prohibited for tool coordinates
2
: Switching prohibited for user coordinates
3
: Switching prohibited for tool coordinates and user coordinates
Parameter Setting
Value
Operation Units
0
MOVL
DOUT
TIMER
DOUT
MOVL
Stops at every instruction
1
MOVL
DOUT
TIMER
DOUT
MOVL
Stops at move instruction
443 of 554
