EN-17
Keypad Operation
Digital Operator Display (optional)
The key names and functions of the Digital Operator are described below
Digital Operator Keys
Note: Except in diagrams, Keys are referred to the key names listed in the above table.
Key
Name
Function
LOCAL/REMOTE Key
Switches between operation via the Digital Operator (LOCAL) and the settings in
b1-01 and b1-02 (REMOTE).
This key can be enabled or disabled by setting parameter o2-01.
MENU Key
Selects menu items (modes).
ESC Key
Returns to the status before the DATA/ENTER key was pressed.
JOG Key
Starts jog operation when the inverter is operated by the Digital Operator and d1-18
is set to 0.
FWD/REV Key
Selects the rotation direction of the motor when the Inverter is operated by the Digi-
tal Operator.
Shift/RESET Key
Sets the active digit when programming parameters.
Also acts as the Reset key when a fault has occurred.
Increment Key
Selects menu items, sets parameter numbers, and increments set values.
Used to move to the next item or data.
Decrement Key
Selects menu items, sets parameter numbers, and decrements set values.
Used to move to the previous item or data.
DATA/ENTER Key
Enters menus and parameters, and set validates parameter changes.
RUN Key
Starts the Inverter operation when the Inverter is controlled by the Digital Operator.
STOP Key
Stops Inverter operation.
This key can be enabled or disabled using parameter o2-02 when operating from a
source different than the operator.
-DRIVE-
-Rdy-
Frequeny Ref
U1-01 = 50.00Hz
U1-02 = 50.00Hz
U1-03 = 10.50A
Drive Status Indicators
FWD:
Lights up when a forward run command is input.
REV:
Lights up when a reverse run command is input.
SEQ:
Lights up when any other run command source
than the digital operator is selected
REF:
Lights up when any other frequency reference
source than the digital operator is selected
ALARM:Lights up when an error or alarm has
occurred.
Data Display
Displays monitor data, parameter numbers and param-
eter settings.
Mode Display
(displayed at the upper left of data display)
DRIVE:
Lights up in Drive Mode.
QUICK:
Lights up in Quick Programming Mode.
ADV:
Lights up in Advanced Programming Mode.
VERIFY:
Lights up in Verify Mode.
A. TUNE:
Lights up in Autotuning Mode.
Keys
Execute operations such as setting parameters, moni-
toring, jogging, and autotuning.