YASKAWA FSDrive-MV1000 Series, Instructions For Use Manual

Page: 45 / 260

2.2 Mechanical Installation
YASKAWA ELECTRIC TOEP C710687 02B FSDrive-MV1000 Instructions 45
Mech
ani
c
al
In
st
al
la
ti
on
2
When using rollers to move the drive panel, make sure that the following conditions are met. Improper handling could
result in damage to the drive.
• Place the panel on the rollers while adjusting their positions so that they extend approximately 100 mm each side of the
panel’s frame.
• Distribute the weight of the drive evenly on the rollers so stress is evenly distributed on the bottom of the drive.
• Create a smooth, even surface for rolling by laying boards flat on the floor. Use boards with sufficient strength and
durability, and make sure the boards do not have gaps between them.
Table 2.4 Transportation Procedure 1 (Class: 2 kV)
Transportation Procedure
1. Attach the wire ropes for lifting to the support hooks on the top of the panel to lift the drive.
Figure 2.2
Figure 2.2 Inserting Wire Ropes for Lifting
2. Ensure that the hanging angle is 45
°±
15
°
.
Front view
Top view
Wire ropes for lifting
Drive
Hanging angle of 45
°
±15
°