44
YASKAWA
TOEPC7106171FD FP605 DRIVE INSTALLATION & PRIMARY OPERATION
9.
Tighten the bolts to the specified torque.
Figure 7.12 Tighten the Terminal Block Bolts
10.
Put the terminal cover back in its initial position.
■
Wiring the Main Circuit Terminal Block Using Procedure C
Main Circuit Terminal Block Wiring Procedure
1.
Remove the terminal cover.
2.
Remove the screws that attach the conduit bracket and remove the conduit bracket from the drive.
A - Conduit bracket
Figure 7.13 Remove the Conduit Bracket
3.
Put the end of a straight-edge screwdriver into the center hole and move it up and down to remove the knock-
out hole.
WARNING
Injury to Personnel. Carefully move the screwdriver to remove the knock-out holes. If you use too much
pressure on the circular metal plates, they can eject and cause injury.
