44
YASKAWA ELECTRIC
TOEP C710656 10B YASKAWA Power Regenerative Unit - R1000 Instruction Manual
3.7 Top Protective Cover
3.7 Top Protective Cover
Models 2A03P5 to 2A0028, 4A03P5 to 4A0028 are designed to IP20/NEMA Type 1 specifications with a protective
cover on the top. Removing this top protective cover or the bottom conduit bracket from an IP20/NEMA Type 1
enclosure models voids the NEMA Type 1 protection while maintaining IP20 conformity.
◆
Removing and Reattaching the Top Protective Cover
Insert the tip of a straight-edge screwdriver into the small opening located on the front edge of the top protective cover.
Gently apply pressure as shown in the figure below to free the cover from the regenerative unit. Insert the two small
protruding hooks on the rear side of the top protective cover into the provided mounting holes near the back of the
regenerative unit, then press down on the front side of the top protective cover to fasten the cover into place.
Note:
Removing the top protective cover or the bottom conduit bracket from an IP20/NEMA Type 1 enclosure drive voids the NEMA
Type 1 protection while maintaining IP20 conformity.
Figure 3.17
Figure 3.19 Removing and Reattaching the Top Protective Cover
Protective Cover
Mounting Holes
R1000
TOEP_C710656_10B_1_0.book 44 ページ ２０１５年１月８日 木曜日 午後８時５５分
