YASKAWA CIMR-RA Series, Instruction Manual

Page: 59 / 209

3.11 Wiring Checklist
YASKAWA ELECTRIC TOEP C710656 10B YASKAWA Power Regenerative Unit - R1000 Instruction Manual 59
El
ect
ri
c
al
In
st
al
la
ti
o
n
3
3.11 Wiring Checklist
No. Item Page
Regenerative Unit, Peripherals, Option Cards
1 Check regenerative unit model number to ensure receipt of correct model. 19
2 Make sure you have the correct peripheral devices. –
3 Check the option card model number. –
Installation Area and Physical Setup
4 Ensure that the area surrounding the regenerative unit complies with specifications. 23
Power Supply Voltage, Output Voltage
5
The voltage from the power supply should be within the input voltage specification range of the
regenerative unit.
–
6 The total load must be within the output specifications of the regenerative unit. 19
7
A power supply with a capacity (kVA) that is larger than the rated input capacity of the regenerative
unit must be used.
–
8 The ratings must be correct. 19
Main Circuit Wiring
9 Confirm proper branch circuit protection as specified by national and local codes. –
10 Properly wire the regenerative unit. 37
11 Suitable wires must be used to wire the power supply and regenerative unit. 45
12 Properly ground the regenerative unit. Review page 49 . 49
13
Tighten control circuit and grounding terminal screws.
Refer to
Wire Gauges and Tightening Torque on page 45
45
Control Circuit Wiring
14 Use twisted-pair line for all regenerative unit control circuit wiring. 55
15 Ground the shields of shielded wiring to the GND terminal. 35
16 Properly wire any option cards. –
17 Check for any other wiring mistakes. Only use a multimeter to check wiring. –
18
Properly fasten regenerative unit control circuit terminal screws. Refer to Wire Size and Torque
Specifications on page 54 .
54
19 Pick up all wire clippings. –
20 Ensure that no frayed wires on the terminal block are touching other terminals or connections. –
21 Properly separate control circuit wiring and main circuit wiring. –
22
The line between the input-side AC reactor and regenerative unit must be 10 m or shorter and the DC
bus line between the regenerative unit and drive must be 5 m or shorter.
–
TOEP_C710656_10B_1_0.book 59 ページ ２０１５年１月８日 木曜日 午後８時５５分