model no. 060-2293-6 | contact us: 1 866 523 5218
model no. 060-2293-6 | contact us: 1 866 523 5218
Operation
!
WARNING! If the battery is inserted into the charger when
warm or hot, the ChECK BATTERY indicator light may
switch on. If this occurs allow the battery to cool outside of
the charger for 30 minutes.
Operation
Operating instructions
Trimmer Tips
Checking the Charge
If the battery pack does not charge properly:
• Check the current at the power outlet with another tool.
Make sure that the outlet is not turned off.
Charger mounting
1. This charger can be installed hanging on a wall using two screws (not supplied).
2. Locate the placement for the charger to be wall mounted.
3. If fastening to wood studs, use 2 wood screws.
4. Drill two holes 2 1/3” (6 cm) on centre, ensuring they are level.
5. If fastening to drywall, use wall anchors and screws to secure the charger to the wall.
Charging Procedure
With regular use, the battery pack will need approx 1 hour or less to fully charge. Allow the
battery to fully discharge before recharging. It is recommended to charge the battery pack
every 3 months when not in use.
1. Plug the charger into an AC power outlet.
2. Insert the battery pack (3) into the charge, the power LED (1) will turn red. Make sure the
latch and battery are fully inserted into the charger.
3. Wait 5 seconds, the status LED (2) will turn red, indicating a connection to the power
source and that the battery is charging.
4. When the battery has become fully charged, the status LED (2) will turn green. The
battery can be stored in the charger, as long as the charger is not plugged in.
NOTE: During charging operation if the Status LED begins to flash red, indicating that the
battery requires replacing.
• Recharge the battery pack anytime you notice there is
less power.
• Disconnect the charger from the AC power outlet when
not in use and once battery has reached a full charge.
10
11
1
2
3
