> 1 m
> 2 m
Quick start of Robot mower
1
2
Place the charging station
Make sure that the garden ground is even and
free of obstacles such as stones, branches.
Remove them if there is.
Select S1 or S2 with the
signal button. It is to
prevent disturbance
with your neighbor
who runs a same robot.
On your mowing robot,
the same setting must
be selected both on the
robot itself and charging
station (S1 or S2).
3
5
Programming the mowing robot
4
Begin with the
maximum cutting
height and gradually
reduce it to the
desired cut height.
Main switch
On/Off switch
Cutting height adjust
<
100 m
2
10 Ω
A
C
Set the boundary wire
with pegs.
E
J
A
I
A
B
A
Close the cover
C
D
For a lawn area less than
100 m
2
or the boundary total
length is less than 40m.
You need a 10 Ω/20 W
cement resistor in boundary.
A
Stripping pliers
10 - 15 mm
G
Possible position of the
charging station
End point of the
boundary wire
1 meter of wire reserved for
possible adjustments
Start point of
the boundary
wire
D
The pegs and the boundary wire
should be as close as possible to
the ground to prevent tripping.
F
H
In front of the loading station, a
straight wire length of 2 m is required.
Beside the charging station
there should be 1m wide
Flat area.
B
To unlock, press 4 times
this “lock” button
Please press “Start”
Select the mowing hours that the
robot should work
®