Yanmar ViO80-1A, User Operation And Maintenance Manual

Page: 143 / 215

16 Transporting the machine
126
16.4 Slinging the machine
WARNING
Never lift the machine with someone on it or on an accessory.
Use a slinging method that is compatible with the weight of the machine
and that complies with current standards.
If you do not lift the machine as shown, it will be out of balance.
Do not pivot the machine when it has been raised.
Never walk under or beside a suspended machine.
1. Pivot the upper structure so that the blade is behind the operator's seat.
2. Lift the blade to the maximum limit.
3. Place the equipment in the longitudinal axis of the machine.
4. Place all the equipment cylinders to maximum extension (except the rotation cylinder).
5. Stop the engine, put the levers in the locked position and check that you have left nothing
around the operator's seat before leaving the machine.
A = Front side
B = Back side
a = Lifting holes at each end
3 Warning labels, page 6
• Lift the machine as follows:
1. Hook the shackles to the suspension holes at the
rear (2 points).
2. Pass the sling between the boom's cylinder and
the boom. Install the sling in a sleeve or a sheath to
protect it from sharp edges of the machine during
slinging.
3. Load lifting accessories carefully.
4. Gently suspend the machine and wait until it sta-
bilises before continuing to lift it.
Length (m) WLL
5
(t)
C 2 m 9
D 4 m x 2 9
5.
Working Load Limit (WLL)