Yanmar ViO80-1A, User Operation And Maintenance Manual

Page: 126 / 215

11 H
ANDLING OF ACCESSORIES
11.1 Hydraulic hammer SOCOMEC
Usage recommendations
WARNING
Before using the machine with a hydraulic hammer, close the front wind shield to work
safely.
WARNING
During the work phase, keep everyone out of the 20m danger zone.
IMPORTANT
•
The hammer must be at 90° to the working surface.
• In a submerged area, make sure that the water does not reach the body of the
hammer.
Note
The hammer can only operate within the following temperature range:
[-5°C ~ +45°C]
• To avoid damaging the structure of the hammer and minimize vibration, the operator must
be smooth when using the tool.Be sure to set the engine speed if you are using a hammer.
• Once the work requiring the hammer is finished, set the hammer vertically with respect to
the ground and leave it in this position to facilitate drainage of condensation on the side of the
piston.
109