ALTERNATOR
12-14
TNV DI Service Manual
Alternator
9. Remove the stator assembly
(Figure 12-10, (1)) from the front frame
housing.
Figure 12-10
10. If it is necessary to replace the bearing
(Figure 12-10, (2)) in the front frame housing,
remove the four bolts (Figure 12-10, (3))
securing the plate (Figure 12-10, (4)) to the
front frame housing. Remove the plate. Use a
puller to remove the bearing. Discard the
bearing.
11. If it is necessary to replace the bearing
(Figure 12-11, (1)) in the rear frame housing,
use a puller to remove. Discard the bearing.
Remove the bearing cover (Figure 12-11, (2))
and two thrust washers (Figure 12-11, (3)).
Figure 12-11
Reassembly of Alternator
1. If removed, reinstall the two trust washers
(Figure 12-12, (3)) and bearing cover
(Figure 12-12, (2)) in the rear frame housing.
Lubricate the outside diameter of a new bearing
(Figure 12-12, (1)). Press the bearing into the
rear frame housing.
Figure 12-12
1
2
4
3
0000259A
1
2
3
0000260A
1
2
3
0000260A
TNV_DI_SM_A4.book 14 ページ ２００７年１２月６日 木曜日 午前９時２３分