YZ-X2
14
3.4 Battery Maintenance
The power system of this washing machine is powered by two
12V maintenance-free lead-acid batteries in series, and the system
voltage is 24V.
●When the machine works for a period of time, the battery power
drops, and when the last bar of the power display meter is flashing,
it means that the power is insufficient and needs to be charged in
time;
●When maintaining the battery, please wear protective gloves to
avoid contact with the acid substance of the battery;
● Check whether the battery connecting wire is worn and the
contact parts are loose, and replace it if necessary;
●The terminal of the battery should be kept clean and dry, and
there should be no debris and dust covering it, which is extremely
unfavorable to the battery, and will burn the battery in severe
cases.
Step 1: Align the
holes of the front
rubber strip with the
protrusions of the
plastic assembly of
the squeegee;
Step 2: Fix the plastic
components on the
cast aluminum base
plate of the
squeegee;
Step 3: Align the
holes of the rear
rubber strip with the
plastic components of
the squeegee to the
protrusions;
Step 4: Use both ends
of the bead to snap
together;
Step 5: Tighten the
Nuts.
! ! Notice
◆
In order to make the battery have a long service life, it should be charged in time
after the machine is finished, and deep discharge is strictly prohibited.
◆
The correct charging method of the lead-acid battery: first insert the battery, then
plug in the mains; when fully charged, first cut off the mains, and then pull out the
battery plug.
◆
If the machine is not used for a long time, please fully charge the battery, disconnect
the positive pole of the battery, and store it.
