11
YZ-S3
Instruction Manual
Be careful! Be careful!
Side brush replacement
Vibrating dust
Filter cleaning and integrity inspection (FIG. 15)
The hard brush or soft brush can be selected according to the ground conditions; when
replacing the main brush, it is better to wear gloves because it may be cut by the brush;
the running direction of the main brush is shown in Fig. 6, and the main brush should
be installed correctly as shown in the figure, and the pressure between the main brush
and the ground should be checked according to the description in relevant chapters.
The main function of the side brush is to use its own rotation to collect the garbage
from both sides to the middle, which is collected by the main brush into the dustbin.
The advantage of the edge brush is that it can sweep out the garbage at the edges and
dead corners and increase the cleaning area.
Use the machine on level ground and turn the machine start key to "off" position;
Lift up the machine and loosen the four bolts at the bottom of the brush plate (FIG.
13);
Replace with a new side brush;
Adjust the height of the side brush
according to the above section.
12
13
14
15
After the sweeper works continuously for a period of time, the
capillary hole of the filter is easy to be blocked. Please use the
dust vibrating function regularly
Pull the dust vibrating rod on the side of the dustbin about ten
times to shake off the dust on the filter. Figure 14
Use the machine on level ground, turn the machine start key
to the "off" position and remove the dustbin.
· scrape the bottom of the filter with a burr free bar.
Please pay attention to the following: do not use water or
detergent to clean it, the filter will be damaged.
Check the filter for cracks. If so, replace it.
