53
7. How to use the communication interface
settemp
Purpose
Request for a target temperature setting.
Description
When BF500 receives this command, it sends an echo back and the target
temperature set at the time of reception. The contents of the target temperature
are the same as those on the operation panel of BF500. The echo back and the
transmission data are as follows:
Settemp <CR> <LF>
n <CR> <LF>
(n means a remote target temperature)
01>
Caution
The target temperature BF500 sends in response to this command is only the
remote target temperature set using the target temperature setting command
described in the next section.
Settemp_n (The underbar “_” means a space)
Purpose
Setting a target temperature.
Parameter
n where n is a numeric value within the temperature setting range of BF500 and
the effective digit is one decimal place (BF500 will ignore any numeric data of two
decimal place of smaller).
Description
BF500 sends an echo back and the ID prompt when it receives this command
from the host and sets n as the new target temperature. The echo back and the
transmission data are as follows:
settemp_n <CR> <LF>
01>
（
The underbar “_” means a space.
）
Caution
BF500 accepts this command irrespective of whether it is in the remote state or
not, which is because the remote target temperature has been set before the
remote operation start command is issued.
setpump
Purpose
Request for a speed level setting of the internal stirring pump (1 to 10 levels).
Description
BF500 sends an echo back and the remote pump speed level (1 to 10 levels)
when it receives this command from the host. The echo back and the
transmission data are as follows:
setpump <CR> <LF>
n <CR> <LF>
(n means a remote pump speed level.)
01>
